To make a more forceful braking, the most effective way is to upgrade the entire brake system

To make a more forceful braking, the most effective way is to upgrade the entire brake system. Typically the original car is a 13-inch or 14-inch wheels, the car people would like to play it increased to 15 inches or 16 inches, so a brake disc can be increased to 282mm. If the original is a 15 or 16-inch wheels, then it can be increased to 17 or 18 inches, while the disc can be increased to 330mm or 380mm, no matter what kind of disc brakes, which are used in ventilation type construction and requires dash or dash add punch, this was done to increase the braking force generated by the brakes and strengthen ventilation effect. Meanwhile brake calipers should be changed from the original single-piston unilateral right to four-piston, or even on the six-piston (for the four to six pairs of pistons and piston means: brake caliper on each side with two or three pistons). This configuration can multi-piston brake calipers of pressure generated by a more balanced distribution of the brake pads on the left and right sides, which produces a braking force is several times the original car, and this brake system configuration brakes can withstand 800 degrees high temperature, turbos for sale the heat generated during braking recession almost disappeared. Because the disc with a dash of auxiliary cooling ventilation design, disc material is also used steel and alloy steel or tungsten to special treatment, hardness higher heat resistance is also stronger. At the same time strengthen the brake hoses brake kits used are replaced with high-temperature expansion of metal braided high pressure hose. The brake pipe factory in Gaza due to the use of rubber mesh material, could not withstand the high temperatures generated during braking, thermal expansion and thus easy to partly offset the braking force. So replacing the metal braid tubing material is absolutely necessary. turbocharger manufacturers